The rear shocks in your Toyota Tacoma do a number of work. They’re designed to cushion the usually harsh journey that comes from a leaf spring rear suspension, but additionally to assist cease perpetual bouncing while carrying a heavy load. If they go out, you’ll comprehend it fairly shortly, and you’ll want to exchange them as quickly as potential so you don’t have problems controlling the vehicle. On this case, the challenge car is a 2003 Toyota Tacoma, but the course of is analogous for different autos as well.
Toyota Tacoma Shock Installation Instructions
1. Raise up the vehicle utilizing the jack and place it on jack stands. Be certain that the vehicle is secure earlier than you crawl underneath it.
2. Unbolt the higher mount on the rear shocks utilizing an open-end wrench, and place the bolt to the side. Unbolt the underside mount on the shock utilizing a 3/eight-inch ratchet and socket, and place that bolt to the side. Take away the shock from the vehicle.
3. Place the replacement shock onto the higher mount and thread the bolt on loosely with your arms in order that the shock nonetheless has some room to move. Hold the underside of the shock with one hand, then minimize the strap that holds the shock together using the scissors and your free hand. The shock will increase nearly instantly, so hold it steady with your arm and guide it onto the lower mount because it expands.
4. Install the decrease shock bolt onto the shock utilizing the 3/8-inch ratchet and socket, then tighten the upper shock bolt utilizing an open-end wrench. Repeat the process for the other shock on the rear of the vehicle.
5. Raise the vehicle off of the jack stands utilizing the jack and place the car again on the ground.
